First you need to remove the DVD drive from the Xbox 360.

For this tutorial we are using a Liteon 93450 DVD Drive.

.

1. Remove the 4 screws



2. Cut the white sticker



3. Remove the bottom metal plate



3. Disconnect these 3 cables



4. Remove these 2 screws



5. Push the plastic latch as shown and then unplug the DVD Control Board





6. This is the area we will be working with



7. Use an exacto knife and make 3 small cuts where the red lines are. You can use the same knife or a fiber glass pen and clean up the 5 holes to make solder contact better.



8. This is the board prepared. Its very simple and does not take long. Advanced fitters take about 30 seconds to do this. Some people take 5 minutes - some take longer.



9. This is where you will install the Xecuter LT Switch. Simply solder the 6 points to the DVD Controller Board.



10. Finished !



11. Now connect the DVD Controller board to a 360 Xtractor Or CK3 Move the switch to the NORMAL position. The LED will light up green.





12. Using the latest Jungle Flasher (v0.1.69 at time of press) you should see the DVD drive properties if everything is connected and setup correctly.



13. Press the Intro/Device ID Button.



14. Now Click Yes.



15. Turn the power OFF on the 360 Xtractor or CK3. Move the Lt Switch to the R/W position. Turn the 360 Xtractor or CK3 ON.
The Led should now be RED.



15. You should now get Status 0x72 and you are in vendor mode. As soon as you see the flash chip properties switch the LT Switch to Normal right away (Green LED). You can now full dump your Liteon firmware and program as normal if you don't get 0x72 then simply retrace your steps and try again. We have done this process many dozens of times and our testers have now done hundreds of consoles.

When done correctly it works every time.